Q-Seal 290S

Description: Q-SEAL 290S Detector Loop Sealant is a one component thixotropic moisture curing polyurethane sealant. It is designed for use in both asphalt and concrete pavement to provide a weather and chemical resistant waterproof seal.

Use: Q-Seal 290S is used as a protective seal for traffic detector wire loops employed in actuated intersections. It may be used as a sealant for saw cuts in concrete or asphalt surfaces.

Curing: Q-Seal 290S will skin over in approximately 3 hours at 77°F and 50% R.H.= (Relative Humidity). At temperatures below 77°F this product will take proportionately longer time to cure. At temperatures above 77°F it will take a proportionately shorter time to cure.

Surface Preparation: Remove standing water. The substrate should be dust free and as smooth as possible before installation of Q-Seal 290S. It is recom-mended that surface temperatures at time of sealant application should not exceed 100°F nor fall below 35°F.

Safety & Handling Precautions: Contains MDI (methylene diisocyanate). Keep away from heat and open flames. Use only in well ventilated areas. Do not breath vapors. In case of contact, immediately flush eyes or skin with plenty of water for at least ten minutes. If contact is made with eyes, get immediate medical attention.

LIS, Inc. - Q-Seal 290 Inductive Loop Sealant, Sealer,Traffic Detector Inductive Loop Sealant, Sealer, One Part Polyurethane, Page 1

• Home • Ordering • Company Information • Index Page 1 • Index Page 2 • Index-Page 3 • Reference • Request Product Information •

Packaging: Q-Seal 290S is available in 5 gallon pails and 30fl.oz. caulking cartridges.

Clean Up: Use Chemque solvent S-231 or S-235. Caution: Clean equipment after use. Use Chemque Q-CLEAN to remove sealant from your hands.

Chemical Resistance: Q-SEAL 290 exhibits exceptional chemical resistance to De-icing Salts, Calcium Chloride, Gasoline, Motor Oil and Hydraulic Break Fluid