Preformed Saw Cut Style

Saw Cut Style Inductive Loop Installation, Page 3

 

Inductive Loop

 

Saw Cut Style Inductive Loop, Page 1

PDF Cut Sheet

 

 

 

 

 

 

 

Preformed Saw Cut Inductive Loop Vehicle Detector, Designed for vehicle detection with: Barrier Gates, Gate Operators, Arming Devices, Overhead Doors, Vehicle Counters, Doors Traffic Signals. Wires will not float to the top of the saw cut while the sealer is curing. Thus preventing wire exposure and potential premature loop failure. Backer Rod is not required. The loop wires will remain at the bottom of the cut with out assistance. This allows for full encapsulation of the loop wires by the sealer. As a result, a more reliable installation is achieved. One continuous wire through out the loops turns and leads. Install the 18Ga Loop in a 1/8” X 1” saw cut in minutes.

A wide selection of loop sizes and lead-in length in inventory and ready for shipment:
   2¢ x 6¢   4¢ x 8¢    6¢ x 12¢   6¢ x 18¢
  2.5¢ x 6¢  4¢ x 9¢  6¢ x 13¢ 6¢ x 19¢
  3¢ x 6¢  4¢ x 10¢ 6¢ x 14¢ 6¢ x 20¢
  3.5¢ x 6¢  4¢ x 11¢ 6¢ x 15¢ 6¢ x 22¢
   4¢ x 6¢   4¢ x 12¢  6¢ x 15¢  6¢ x 24¢
 4¢ x 7¢ 5¢ x 12¢ 6¢ x 17¢ 6¢ x 26¢

  Saw Cut Style Inductive Loop, Page 1

  Choice of XLP Insulations:

Thin Wall (TW) & Std. 18 & 14 Ga. XLP

  Non-spliced stock leads are         

20', 30', 50', 75' & 100'
  Custom size loops available,
  Custom non-spliced lead lengths

   Saw Cut Style Inductive Loop Installation, Page 3  

• Home • Ordering • Company Information • Index Page 1 • Index Page 2 • Index-Page 3 • Reference • Request Product Information •